HVAC static cost scenario
Furnace Size & Cost in San Francisco, CA
The modeled typical cost is $8,880, with a planning range of $6,660 to $11,987 for San Francisco, CA.
Computed cost breakdown
| Line item | Arithmetic basis | Amount |
|---|---|---|
| Materials | 1,800 sq ft × indexed material rate | $4,613 |
| Labor | 1,800 sq ft × indexed labor rate × 1.34 | $3,697 |
| Permits | Baseline allowance | $300 |
| Disposal | 1,800 sq ft × disposal rate | $270 |
| Typical total | $8,880 | |
Low $6,660 · Typical $8,880 · High $11,987
Difference from the parent scenario
San Francisco, CA uses a 1.34× labor factor, 33.8% above the national wage factor. The resulting total is 11.8% above the parent national total because materials and fixed allowances do not change.
Open the interactive furnace size & cost to change quality, scope, contingency, or ZIP.
San Francisco, CA metro calculation record
San Francisco, CA is Census CBSA 41860, ranked 13 among the 50 metros evaluated for this release, with a 2025 population estimate of 4,630,041. Its BLS wage factor changes the modeled labor line from $2,762 nationally to $3,697 here, a difference of $935. The complete project moves from $4,414 to $4,933 per 1,000 sq ft after materials and fixed allowances remain unchanged.
Primary cost controls
- Equipment capacity and efficiency
- Ductwork or electrical changes
- Number of zones
- Climate and design load
This worksheet starts with home area to form a furnace-capacity planning scenario, then attaches the modeled equipment and installation budget. It does not perform a room-by-room Manual J load calculation or select fuel, venting, duct changes, electrical work, or combustion-air requirements. Use its capacity result to frame questions; require the installer to document the design load and chosen furnace output.
Questions about this scenario
What is the modeled typical cost for San Francisco, CA?
The static default is $8,880, with a planning range of $6,660 to $11,987 from the shared calculator record.
What changes from the national calculator?
Only labor uses the 1.34× metro wage factor. Materials, permits, disposal, baseline date, and index series remain tied to the parent model.
Is this a local contractor quote?
No. It is a static planning scenario generated from the public baseline store. Confirm site conditions, scope, code requirements, and price in written local proposals.