HVAC static cost scenario
Furnace Size & Cost in Minneapolis, MN
The modeled typical cost is $8,450, with a planning range of $6,337 to $11,407 for Minneapolis, MN.
Computed cost breakdown
| Line item | Arithmetic basis | Amount |
|---|---|---|
| Materials | 1,800 sq ft × indexed material rate | $4,613 |
| Labor | 1,800 sq ft × indexed labor rate × 1.18 | $3,267 |
| Permits | Baseline allowance | $300 |
| Disposal | 1,800 sq ft × disposal rate | $270 |
| Typical total | $8,450 | |
Low $6,337 · Typical $8,450 · High $11,407
Difference from the parent scenario
Minneapolis, MN uses a 1.18× labor factor, 18.3% above the national wage factor. The resulting total is 6.4% above the parent national total because materials and fixed allowances do not change.
Open the interactive furnace size & cost to change quality, scope, contingency, or ZIP.
Minneapolis, MN metro calculation record
Minneapolis, MN is Census CBSA 33460, ranked 16 among the 50 metros evaluated for this release, with a 2025 population estimate of 3,790,295. Its BLS wage factor changes the modeled labor line from $2,762 nationally to $3,267 here, a difference of $505. The complete project moves from $4,414 to $4,694 per 1,000 sq ft after materials and fixed allowances remain unchanged.
Primary cost controls
- Equipment capacity and efficiency
- Ductwork or electrical changes
- Number of zones
- Climate and design load
This worksheet starts with home area to form a furnace-capacity planning scenario, then attaches the modeled equipment and installation budget. It does not perform a room-by-room Manual J load calculation or select fuel, venting, duct changes, electrical work, or combustion-air requirements. Use its capacity result to frame questions; require the installer to document the design load and chosen furnace output.
Questions about this scenario
What is the modeled typical cost for Minneapolis, MN?
The static default is $8,450, with a planning range of $6,337 to $11,407 from the shared calculator record.
What changes from the national calculator?
Only labor uses the 1.18× metro wage factor. Materials, permits, disposal, baseline date, and index series remain tied to the parent model.
Is this a local contractor quote?
No. It is a static planning scenario generated from the public baseline store. Confirm site conditions, scope, code requirements, and price in written local proposals.